Instructions:
With some applications it is important to set a counter back to its initial value as quickly as possible when it reaches specific comparison value.
Furthermore, normally at the moment of resetting a series of calculations are made to determine the next comparison value (to optimize the point of intersection of the material).

You have the option of doing a reset also without the standard function FC CNT_CTRL.

Proceed as follows to configure the counter for fast reset:

1. In the "Properties" dialog box of the counter module, in the "Basic parameters" area, set the option Generate interrupt to "YES" and the option Interrupt selection to "Process". In this way you generate an interrupt at the moment of resetting.